FS: Built 6bolt DSM motor
#1
RIP Chris Schader
Thread Starter
FS: Built 6bolt DSM motor
Name: Devan
Location: Newport News, VA
contact: AIM or PM [aim: SnapOn]
so i'm thinking about getting out of the dsm game for now because I want to boost an IS300 or get a bike. If someone buys this then I will begin my partout. all work has been done by me besides the machine work. I am very experienced with DSMs and have built MANY motors for them. everything has 900 miles on it for break-in and it runs strong.
you're looking at $2300 firm picked up for this longblock. .
6 Bolt block bored .20 over and performance honed using deckplate .055 Piston wall clearance
hot tanked
decked flat
all rotating assy balanced
all machine work done by Virginia Speed (have reciepts)
Ross .20 8.5:1 pistons
eagle H-beam conrods
ACL race bearings
All ARP hardware (headstuds, mains, rods)
balance shafts removed
cometic mls headgasket
brian crower 280/280 cams
brian crower springs/retainers
blue viton vs seals
AEM tru-time adj cam gears
video: ------
pics:-------
Location: Newport News, VA
contact: AIM or PM [aim: SnapOn]
so i'm thinking about getting out of the dsm game for now because I want to boost an IS300 or get a bike. If someone buys this then I will begin my partout. all work has been done by me besides the machine work. I am very experienced with DSMs and have built MANY motors for them. everything has 900 miles on it for break-in and it runs strong.
you're looking at $2300 firm picked up for this longblock. .
6 Bolt block bored .20 over and performance honed using deckplate .055 Piston wall clearance
hot tanked
decked flat
all rotating assy balanced
all machine work done by Virginia Speed (have reciepts)
Ross .20 8.5:1 pistons
eagle H-beam conrods
ACL race bearings
All ARP hardware (headstuds, mains, rods)
balance shafts removed
cometic mls headgasket
brian crower 280/280 cams
brian crower springs/retainers
blue viton vs seals
AEM tru-time adj cam gears
video: ------
pics:-------
Last edited by g S x; 08-31-2008 at 10:52 AM.
#2
Re: FS: Built 6bolt DSM motor
bump for Devan. Good guy to deal with, and always has a sick DSM. gl with the sale bro
#6
Re: FS: Built 6bolt DSM motor
Very nice setup motor here guys. If you have any other DSM parts for a 1G lets me know im always looking for deals lol. If i had the money setting around i would pick this up for my COlt project.
Thread
Thread Starter
Forum
Replies
Last Post