JG B16A3 block (0 miles) COMPLETE!!!
B16A3 crank (0 miles)
magilla sleeves (stock bore)
balanced, blue printed, "rev-matched" for 12,000rpms
mahle 11:3 forged pitons (500 miles)
hastings piston rings (0 miles)
eagle H-beam rods (500 miles)
ACL race bearings (0 miles)

i paid $1475 for the block,sleeves, and crank, assembled, balanced, blue printed, and rev matched, straight from JG in california.

i also paid around $700 for the pistons and rods which were in a previous build that started to slightly crank walk right at the 500 mile break in.

block is completely assembled including mugen thermostat, mugen fan switch, new oil pump, new oil pick up with girdle, and new timing tensioner. new oil pan available.

was assembled but had problems with stock head gasket clearance. never started or timed it.

asking $750obo
call andrew for more info. pictures available. 757 871 9539














CHANGE IN PRICE! $750 COMPLETE! COME GET IT!

 

more info on the hg clearance?

 

any pics?? this sounds nice.

 

when i put the head on and torqued it down i attempted to put it at top dead center but the piston was touching the head. i called cometic and they said they could help me but i needed to take alot of measurements and i just didnt have time to do all that. like i said before there was no damage done whatsoever. i will try to post pics tonight. i hate to sell it so cheap but i dont even own a honda anymore . haha

 

Bump!!!

 

so the piston hit the HEAD?

or valves?


will you pull it apart and sell the block bare?

 

the piston was hitting the head but like i said there was no damage done. id really like to sell it all as one.

 

bump!!!

 

Bump for you Drewfus!

 

pics are up!!!!!!