1994 Integra GSR - Built All-Motor CLEAN
SOLD!
BLOCK
-Gsr block
-Nippon Racing .25 over B16 pistons
-ACL race bearings
-ARP rod bolts
-New OEM water pump
-New OEM oil pump
-New OEM rear main seal
-New OEM timing belt
-New OEM tensioner
-New OEM oil pan gasket
-New Cometic head gasket
-Bored, honed and decked by Abacus
HEAD
-Gsr head
-Inline Pro valve springs and retainers
-Skunk2 intake manifold
-Skunk2 70mm throttle body
-Skunk2 stage 2 cams
-DTR header (I paid 800 bucks for this header)
-All new bronze valve guides and seals
-Supertech flat faced valves
-New OEM cam seals
-3 angle valve job and milled by Abacus
TRANSMISSION
-Less than 30k on it
-Exedy stage 1 clutch
-New OEM axle seals
OTHER
-New OEM rear brake pads and rotors
-Lowered on Ground Control coil overs
-Pioneer speakers all around
-Brand new Falken tires
-Energy suspension red motor mount inserts
-Custom intake
-Custom 2.5 exhaust (sounds nice)
-New Inspection
Asking $5200 but taking offers, NO LOW BALLS PLEASE OR TRADES



BLOCK
-Gsr block
-Nippon Racing .25 over B16 pistons
-ACL race bearings
-ARP rod bolts
-New OEM water pump
-New OEM oil pump
-New OEM rear main seal
-New OEM timing belt
-New OEM tensioner
-New OEM oil pan gasket
-New Cometic head gasket
-Bored, honed and decked by Abacus
HEAD
-Gsr head
-Inline Pro valve springs and retainers
-Skunk2 intake manifold
-Skunk2 70mm throttle body
-Skunk2 stage 2 cams
-DTR header (I paid 800 bucks for this header)
-All new bronze valve guides and seals
-Supertech flat faced valves
-New OEM cam seals
-3 angle valve job and milled by Abacus
TRANSMISSION
-Less than 30k on it
-Exedy stage 1 clutch
-New OEM axle seals
OTHER
-New OEM rear brake pads and rotors
-Lowered on Ground Control coil overs
-Pioneer speakers all around
-Brand new Falken tires
-Energy suspension red motor mount inserts
-Custom intake
-Custom 2.5 exhaust (sounds nice)
-New Inspection
Asking $5200 but taking offers, NO LOW BALLS PLEASE OR TRADES



Last edited by RameyBuilt; Dec 18, 2008 at 10:44 AM.





