HELP: Clutch issue
#1
Registered Member
Thread Starter
Join Date: Apr 2007
Posts: 826
Likes: 0
Received 0 Likes
on
0 Posts
![SYCKDC23 has disabled reputation](images/reputation/reputation_off.gif)
![Default](images/icons/icon1.gif)
I got an integra gsr with stage 3 exedy, i have to push the clutch all the way to the floor to switch gears. Theres way to much play in the pedal. How can I tighten this up so the car starts to move when letting out at the top.
Does this involve bleeding the master cylinder?
Does this involve bleeding the master cylinder?
#4
Registered Member
Join Date: Dec 2003
Location: Virginia Beach
Posts: 1,026
Likes: 0
Received 0 Likes
on
0 Posts
![Al_P has disabled reputation](images/reputation/reputation_off.gif)
![Default](images/icons/icon1.gif)
It is not likely bleeding will help unless you opened the system recently.
Crawl under the dash and look up where master is. You will see a rod going to the clutch pedal. There is a 12mm nut on it. brake it loose and adjust the pedal play by turning rod in or out of the clutch pedal.
Crawl under the dash and look up where master is. You will see a rod going to the clutch pedal. There is a 12mm nut on it. brake it loose and adjust the pedal play by turning rod in or out of the clutch pedal.
#5
![Default](images/icons/icon1.gif)
It is not likely bleeding will help unless you opened the system recently.
Crawl under the dash and look up where master is. You will see a rod going to the clutch pedal. There is a 12mm nut on it. brake it loose and adjust the pedal play by turning rod in or out of the clutch pedal.
Crawl under the dash and look up where master is. You will see a rod going to the clutch pedal. There is a 12mm nut on it. brake it loose and adjust the pedal play by turning rod in or out of the clutch pedal.
Thread
Thread Starter
Forum
Replies
Last Post