So I bent my control arm and put a 94 control arm on with no abs so I just took the abs sensors off. But now my brakes sink to the floor. Is it b/c my break master cylinder is bad or was it b/c I took my abs sensors off? Also what would be easier, should I do just get a control arm with abs or is it easier to just keeping the abs sensors off?

Please help.

 

Get a control arm with ABS.

 

But is the sinking of the breaks b/c of me taking the abs sensors off?

 

No, its going to the floor because the brake master cylinder might be bad or had air in the lines. Removing the ABS sensor would only give you a light and abs wouldnt work.

 

so would I put a master cylinder with abs or w/o abs

 

well if you are going to keep abs then its common sense to put an abs MC in. If you plan on deleting abs you need more than just a MC.

 

What would happen if I just put a MC with abs but I dont put the sensors on?

 

you will have the abs light on and abs wont work.

 

So everything would work fine then y do people want to do the full abs delete?

 

have inspection problems in the long run.do it the right way