D-SERIES TRANNY / CLUTCH / Throw Out Bearing, Input Shaft Bearing
11-01-2009, 08:28 PM
#1
EbaySpecial
Thread Starter
Join Date: Aug 2007
Location: yorktown
Posts: 1,227
Likes: 0
Received 0 Likes
on
0 Posts
D-SERIES TRANNY / CLUTCH / Throw Out Bearing, Input Shaft Bearing
Mason
Yorktown (Newport News)
PM / 757-753-6650 (texting would probably be easier since im in school and work)
okay so my input shaft bearing went out in the coupe. (1997 ek D16y8) so i figured while i was taking it apart i would replace the throw out bearing as well, possibly along with a new clutch. just because im tired of mine
but then i thought if i could find a good deal on a tranny with no slips or grinds AT ALL, then i could just buy another tranny so i wouldnt have to go in and replace the bearings, and just throw in my stage 2 clutch from the old tranny.
either way works.
so im looking for any and/or all of these parts:
1. input shaft bearing
2. throw out bearing
3. d-series tranny with NO SLIPS OR GRINDS, id rather just fix my tranny then buy another one that i gotta fix
4. POSSIBLY another clutch (not oem)
thanks
Yorktown (Newport News)
PM / 757-753-6650 (texting would probably be easier since im in school and work)
okay so my input shaft bearing went out in the coupe. (1997 ek D16y8) so i figured while i was taking it apart i would replace the throw out bearing as well, possibly along with a new clutch. just because im tired of mine
but then i thought if i could find a good deal on a tranny with no slips or grinds AT ALL, then i could just buy another tranny so i wouldnt have to go in and replace the bearings, and just throw in my stage 2 clutch from the old tranny.
either way works.
so im looking for any and/or all of these parts:
1. input shaft bearing
2. throw out bearing
3. d-series tranny with NO SLIPS OR GRINDS, id rather just fix my tranny then buy another one that i gotta fix
4. POSSIBLY another clutch (not oem)
thanks
Thread
Thread Starter
Forum
Replies
Last Post
JB@RameyBuilt
Engine / Exhaust / Drivetrain
1
03-31-2009 03:45 PM
Tim-Tim
Parts ARCHIVE
2
12-11-2008 02:24 PM