b18b1 complete long block needs rebuilt. extra clean
Thread Starter
Registered member
Joined: Jun 2005
Posts: 1,640
Likes: 0
From: 757
b18b1 complete long block needs rebuilt. extra clean
Tim
Hampton
pm me
400 obo
i got this motor with a spun rod bearing. needs new crank or crank to be turned and 1 new rod. i was goin to swap the motor over when i got another honda but need the cash asap. the block is a 97 and the head is a 95. all parts are good. it comes complete from oil pan to valve cover. its the b20 stle valve cover with the "honda motor co." shaved off.
powdercoated parts are as followed
valve cover
power steering brackets
ac/torque mount bracket
water tube on back of block
timing belt motor mount
alternator brackets
oil pan
painted items are as followed
ac compressor
power steering pump
intake manifold
harmonic balancer
ac tensioner pulley
cam gears
comes with all 3 accessory belts
starter
t bracket
all sensors on head are good
fan switch
map sensor
tps sensor
iat sensor
new cam seals
new oil pump seal
random seals/gaskets
new valve stem seals
what needs to be bought to put motor back together
head gasket
valve cover gasket
oil pan gasket
thermostat ( i have a new gasket for the t-stat)
if i think of anything else ill post it up.
Hampton
pm me
400 obo
i got this motor with a spun rod bearing. needs new crank or crank to be turned and 1 new rod. i was goin to swap the motor over when i got another honda but need the cash asap. the block is a 97 and the head is a 95. all parts are good. it comes complete from oil pan to valve cover. its the b20 stle valve cover with the "honda motor co." shaved off.
powdercoated parts are as followed
valve cover
power steering brackets
ac/torque mount bracket
water tube on back of block
timing belt motor mount
alternator brackets
oil pan
painted items are as followed
ac compressor
power steering pump
intake manifold
harmonic balancer
ac tensioner pulley
cam gears
comes with all 3 accessory belts
starter
t bracket
all sensors on head are good
fan switch
map sensor
tps sensor
iat sensor
new cam seals
new oil pump seal
random seals/gaskets
new valve stem seals
what needs to be bought to put motor back together
head gasket
valve cover gasket
oil pan gasket
thermostat ( i have a new gasket for the t-stat)
if i think of anything else ill post it up.
Last edited by Tim-Tim; Apr 29, 2010 at 03:29 PM.
Thread Starter
Registered member
Joined: Jun 2005
Posts: 1,640
Likes: 0
From: 757
Re: b18b1 complete long block needs rebuilt. extra clean
had some extra time at lunch today so i stripped down the head to put some serious cleaning into the head. valves were removed and cleaned by a wire wheel. all the carbon built on them is no gone. also recleaned the head intake/exhaust ports and valve seats. heres some pics. also BRAND NEW VALVE STEM SEALS ARE GOING IN TOMORROW.
