I need some help from the honda heads =)
#1
Registered User
Thread Starter
Join Date: Jun 2003
Location: Virginia Beach
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
I need some help from the honda heads =)
Does these intake manifold look and sound like a good deal. Please let me know cause if I can win it I'll be putting it on my b16 crx. Any comments would be appreciated. http://cgi.ebay.com/ebaymotors/ws/eB...RK%3AMEBI%3AIT
Thank you
Doug
Thank you
Doug
Last edited by Jowga28; 07-01-2004 at 03:41 PM.
#5
Registered User
Thread Starter
Join Date: Jun 2003
Location: Virginia Beach
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Re: I need some help from the honda heads =)
Thank you everybody for your advice. I'm still new to the whole honda motor seen I just want to make sure I'm not getting am not being taken for a ride. I think I'll for a type r manifold. But how would I be able to tell if the manifold is a real type r?
#6
Re: I need some help from the honda heads =)
It is a stock b16a manifold that has been barely touched only at the exit point of the runners. It has also been sand/bead blasted. Waste of money if you ask me.
#7
Racetracks
Join Date: Nov 2002
Location: How long is a piece of string?
Posts: 15,668
Likes: 0
Received 0 Likes
on
0 Posts
Re: I need some help from the honda heads =)
It's a B16 manifold, there is a PR3 stamp on it in one of the pictures. So it's just a gasket matched, TB bored B16 manifold. The mods that are done to that manifold you can do yourself. You will get better low end torque than an ITR manifold though, it's true.. If you're keeping your B16 fairly stock, stick with the B16 manifold. The ITR mani won't start making better power until almost your stock rev limit..
#8
Registered User
Thread Starter
Join Date: Jun 2003
Location: Virginia Beach
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Re: I need some help from the honda heads =)
Thanks everybody after reading your replies I decided I'm going to go with a after market intake manifold.