MR2 Wire harness questions
#1
RIP Chris Schader
Thread Starter
MR2 Wire harness questions
I might be buying a 1992 toyota MR2 non turbo that has an Australian 3SGT-E in it. the wiring has been swapped over to the australian turbo harness but the thing is when they sent the wire harness that goes from the engine to the ecu they pulled the plugs off and left the pins. theres like 5 wires that no one seems to know what pins they go in. any tips or info on the australian crap will be appreciated.
#8
RIP Chris Schader
Thread Starter
Re: MR2 Wire harness questions
one of the wires thats just hanging loose has to be for the fuel pump because it wont come on. will it be hard to find the harness that goes from the sensors on the engine to the ecu in the trunk?
#9
brake/steer/throttle
Join Date: Nov 2002
Location: sod off you bloody wanker
Posts: 1,542
Likes: 0
Received 0 Likes
on
0 Posts
Re: MR2 Wire harness questions
do you have a BGB? no, not A haynes or chilton's, but an actual BGB. you may be able to get just the electrical diagram section for the Alltrac
Thread
Thread Starter
Forum
Replies
Last Post
frk_concepts
Engine / Exhaust / Drivetrain
9
03-21-2009 03:02 PM