Engine Building Shops....
#1
Droppin E-Thugs!!!!!
Thread Starter
Join Date: Feb 2003
Posts: 2,050
Likes: 0
Received 0 Likes
on
0 Posts
![reddevil94](images/reputation/reputation_pos.gif)
![reddevil94](images/reputation/reputation_pos.gif)
![reddevil94](images/reputation/reputation_pos.gif)
![reddevil94](images/reputation/reputation_pos.gif)
![reddevil94](images/reputation/reputation_pos.gif)
![reddevil94](images/reputation/reputation_highpos.gif)
![reddevil94](images/reputation/reputation_highpos.gif)
![reddevil94](images/reputation/reputation_highpos.gif)
![reddevil94](images/reputation/reputation_highpos.gif)
![reddevil94](images/reputation/reputation_highpos.gif)
![reddevil94](images/reputation/reputation_highpos.gif)
![Thumbs up](images/icons/icon14.gif)
Where can I have a good builder build my ls/vtec block, just need the crank on and gsr girdle put on, using stock caps or using the gsr caps. Bore and hone the cylinders. I can do the rest of the work just need the honing and boring of the block and need to get a yes or no of the installation of the girdle, I know that machining will have to be a must, just wonderin why it cost so much to have it done. I have done a lot of research and tried explaining to some people about the ideas, that some people have used, and worked on ls/vtec buildups. Your help will be appreciated.....thanks....
Last edited by reddevil94; 10-06-2004 at 08:06 AM.
#2
![Default](images/icons/icon1.gif)
abacus racing does great machine work they have a lot experience with honda motors...talk to chuck there he can help you out...
http://www.abacusracing.com/
http://www.abacusracing.com/
#3
Droppin E-Thugs!!!!!
Thread Starter
Join Date: Feb 2003
Posts: 2,050
Likes: 0
Received 0 Likes
on
0 Posts
![reddevil94](images/reputation/reputation_pos.gif)
![reddevil94](images/reputation/reputation_pos.gif)
![reddevil94](images/reputation/reputation_pos.gif)
![reddevil94](images/reputation/reputation_pos.gif)
![reddevil94](images/reputation/reputation_pos.gif)
![reddevil94](images/reputation/reputation_highpos.gif)
![reddevil94](images/reputation/reputation_highpos.gif)
![reddevil94](images/reputation/reputation_highpos.gif)
![reddevil94](images/reputation/reputation_highpos.gif)
![reddevil94](images/reputation/reputation_highpos.gif)
![reddevil94](images/reputation/reputation_highpos.gif)
![Default](images/icons/icon1.gif)
I am just trying to figure who can put a gsr girdle on a ls integra bottom end.....I have steps on how to due this, but I am seeing if there are any qood shops around that could do it. I have everything that I need to build my ls/vtec motor setup, just need a good builder that will assemble the bottom end for a decent price, I will install all the parts just need the crank in, with the girdle and rods and piston, bore and hone, I will install everything else myself.
Thread
Thread Starter
Forum
Replies
Last Post