alright i got a 89 civic with a b16a in it. has plenty of fuel, timin is correct, spark seems to be ok, everything works all honky dorey, but it wont start. someone hook me up with some good ass advice. if you crank it over it acts like it wants to start it jus doesnt. sometimes it will start for bout 5 secs get up to bout 500-600 rpm and jus bog out and die. If i try to give it gas it jus bogs out and dies. HELP

 

clean the injectors??

 

did that

 

main relay? That happened to mine all the time. Turned out to be the main relay.

 

check your wiring

 

that happened to me when my map and tps wires were crossed. they have the same plugs and its easy to cross them up.

 

spray some either/starting fuel in to the intake mani while someone tries to start it

 

Check Your Ground Wires!

 

dont spray any fuel starter into your mani, then your car will be dependant on that stuff. Double and tripe check all your wires remember first color is the color of the wire, second color is the tracer (line), example: R/Y Red wire with yellow tracer. And make sure all your diagrams are correct.

 

Hey my car is doing the same exact thing. Give it gas, it bogs out. It starts up, but usually cuts immediately. I don't believe I'm having a wiring issue though. It was working fine before, then just stopped running all the sudden. Increasing injector cycle(E-Manage), then keeping it revved at high rpm for a little while will get it idling. It still bogs at certain rpms when reving. Once I get it warmed-up after this, I can return injector cycle to stock and it'll idle. It starts up kind of lean like something is adjusting the amount of fuel and then will barely start up to idle. Any ideas?