1ns0mniac

ok so heres the situation. speedo doesn't work. checked speed sensor. pulled it out. found out there was some needle missing from the tranny/sensor. found it put it back in. still no good. took my brothers speed sensor from his 2000 gsr teg and put in on my ls tranny... still does not work. what else could it be if the speed sensor is fine.

boostedgsrcivic

check the plug see if it corroded thats what happened to mine and no speedo

1ns0mniac

it is corroded. we noticed that when we took of the sensor.

boostedgsrcivic

cut and rewire and problem gone i did it and it fixed mine(bad signal)

1ns0mniac

the plug is corroded but like brother said, Where are we going to get a new or uncorroded plug?

hatch77

Your problem is def. a wiring problem. You either have a cut wire, or a short. Just take it all out and re-wire the sensor into your ECU from scratch.

1ns0mniac

we still need an uncorroded plug. or a new one.

hatch77

U-wrench-it is your best friend

or honda-parts.com should have what you need.

1ns0mniac

when i went to uwrenchit all i saw were cars 1990 and below.. can i use the same plug they use?

hatch77

it all depends on the part number man. Call up Honda or Acura and see if you can get the part number for what you need, and then go and snag it up. It could be the same part. Or, you could look for someone parting their car.