sadly i just recently blew my b20vtec swap in my teg...i am having trouble deciding what i should do with it or what i should do next. I figured my options are i can eather rebuild the engine, witch would intitle getting a new head, getting new valves, getting springs and retains switched over, sleeving the block and replacing a piston and possibly a rod. everything in the motor was aftermarket so its not going to be cheap. or i can scrap the motor, get what i can out of it and pick myself up a cheap b18a put it in my teg using my old manifulds (eldbrock intake with throtle body, and dc sports header) and the tranny that was in it (gsr with phanton grip) and switch over the valvesprings retainers, upgrade the valves in the ls head, put the rods in the ls block and later on down the line get some pistons and run boost. Im kinda up in the air with what i should do and any input on the situation would help...