94_CRVtec

i put a b16 in my 94 teg i blew my b20 vtec with the b16 head and the problem is that when i lightley hit the gas peddle the car tends to rev irradicaly jumping from about 1.5k to 2k and then when it hits about 2.5 or 3 it starts to run right with no probs, the engine is throughing codes it calls out vtec sensor, ait (air intake temp) sensor and the iat (idal air temp) sensor and i was wondering if these might have anything else to do with it?

94_CRVtec

any advice?

StpH8n

The one time i was throwing AIT and IAT, was when i had two connectors backwards. It also caused my motor to rev wierd but only at low rpms (like you). And just like you're saying, right at about 2.5 and 3k it mellowed out and drove normal. This was right after i completed my swap. Figured out what was backwards, swapped em, and the problem was gone.

Fabrik8

Those two sensors can definately make your car run very badly, double check all your wiring, yes..

94_CRVtec

they were backwords...i feel like a dumbass, thx guys

StpH8n

w00t! Im glad my retarded mistake could help you with your retarded mistake....rofl. Now have you seen my baseball................?

SCOOBY STEVE

B16 in a Teg? Hmmm...

SlowLS

How did the b29 vtec run. I;m about to do it.

94_CRVtec

only reason there is a b16 in the teg is becaue it was cheap, a decent motor with low miles, and i need the car to get back and forth