Originally Posted by
C Ory
You should also get new bearings while you're at it. Sometimes the bearings can get screwed up when you remove the hub.
They make a special tool that you can get the hub off of the car while the spindle is still attached. It is just for 90-97 Accords. I know Matco sells it, but I'm not sure who else does.
Ya I know about the bearings, I will have all the parts,just need a laborer.
Just found the part. Too bad its 300 bucks.
But also a slide hammer has been used my tech's as an alternative and has also prevented damaging the bearing. I think I may just try tomorrow using a rummer mallet and a socket the size of the bearing so I only hit the outter edge and not the center.