B16 Head Question
Thread Starter
Banned
Joined: Sep 2004
Posts: 1,985
Likes: 0
From: Virginia Beach
B16 Head Question
I am planning on upgrading the head gasket on my B16. It is turboed and thats why i'm upgrading it. I was wondering if anyone knew how much I have to torque the head down once I put it back on? thanx
BACK IN A G8
Joined: Jun 2004
Posts: 4,028
Likes: 0
From: LEGION OF DOOM
Re: B16 Head Question
BOLT TORQUE SPECS (tightening) / (loosening)
8, 4, 2, 6, 10 <---intake order 3, 7, 9, 5, 1
7, 3, 1, 5, 9 <---exhaust order 4, 8, 10, 6, 2
Torque in steps: 22ft-lbs (264in-lbs), Then to 63ft-lbs (756in-lbs) (final spec) 94+ Teg
Torque in steps: 22ft-lbs (264in-lbs), Then to 61ft-lbs (732in-lbs)(final spec) 90-93 Teg / B16's
8, 4, 2, 6, 10 <---intake order 3, 7, 9, 5, 1
7, 3, 1, 5, 9 <---exhaust order 4, 8, 10, 6, 2
Torque in steps: 22ft-lbs (264in-lbs), Then to 63ft-lbs (756in-lbs) (final spec) 94+ Teg
Torque in steps: 22ft-lbs (264in-lbs), Then to 61ft-lbs (732in-lbs)(final spec) 90-93 Teg / B16's
Thread
Thread Starter
Forum
Replies
Last Post
imcnblu
Want to Buy / Trade ARCHIVE
2
Jun 11, 2008 05:24 PM
wisepanda
Want to Buy / Trade ARCHIVE
6
Sep 11, 2007 02:27 PM
