Its throwing a code 6, coolant temp sensor right? PR3 Chipped In B16 CRX, in limp mode, about 6K redline. I replaced the sensor, but I'm still getting code 6, DAMMIT, please help.

 

Is this a new swap or was it running at one point?

 

It DID work fine, until 2 days ago. So yes, it was running at one point.

 

well if it was a new swap ..for some reason i have done 3 b16 swaps in crx and they all threw code 6 for some odd reason ..and the only way to fix it would be to un hook my reverse lights from my transmission...sounds weird but beleive it or notevery time i hooked them up it through the coolant sensor code ..oww and it only did this in an HF not an si or anything else for sum reason ?? iono

 

It is an HF, and thank you very much, I will try that and let you know if it works. Fucking wierd, I never would have thought of that. After I disconnect them, can I hook back up, or not?

 

Cut the wire going into B9 on the ecu, should be green/black, that will work and no you do not hook it back up.

 

I just pulled the plug on the front of tranny for backup light and it worked. I don't trust myself to cut wires, I'll fuck something up. Thanks for your help.

 

lol for some odd reason i knbew thats what it was but its weird as hell how that works ...exspecially since u said the swap was running fine

 

THATS THE BIGGEST BULLSHIT I'VE EVER HEARD....
...but i had the same problem with a rev limit at 7600, no codes though, i unplugged my reverse switch too and it raised the rev limit to normal. I was like haha wtf, all this time I could have fixed it by this stupid shit. thanks

btw, its a b16 swap in place of the old ls-vtec in an OBD-0 DA integra