Who can run 11.00s and under?
It's got a KB 2.2, Viper spec T-56, built live axle, Bassani X pipe and Mac 3" cat back, DFX clutch, and supporting fuel mods. That's it. I've got a UPR K-member, A-arms, bump steer kit, and CC plates along with some Bassani Mid length headers in my garage waiting for me to have time to put them on.
Here's the thread with the vid of the run from Imports vs Domestics.
https://www.vadriven.com/forums/showthread.php?t=162658
I probably would have gotten the 10 that day if I wouldn't have had to wait 7 hours before my next pass.
Here's the thread with the vid of the run from Imports vs Domestics.
https://www.vadriven.com/forums/showthread.php?t=162658
I probably would have gotten the 10 that day if I wouldn't have had to wait 7 hours before my next pass.
well, least it's a lot lighter
Did you grease the hell out of all the Bushings? Poly bushings can be annoying in the squeek department if not. The squishyness depends on your spring rate, which yours are probably a drag spring.
i went 11.0 earlier this year in a 100% street car with no wieght reduction at all in fact it was heavier than stock .o yea its N/A . and i have a few friends in the 10s and lower in street cars. i myself have a chance of having a 10 sec car this.
I ran 11.2 with the no launch and rev limiter set for 6k. Was set for low boost 10lbs. If I went back I would of bagged my tens, but came across a deal for nice front mount kit and have since decided to revamp the whole car with a cage and what not. Tens in march should be no problem.





If only I could keep up with the car. 