Can someone tell me a list of everything i would to need to do this swap I found a motor and trans but thats all I have to start what else will I need

 

under hood wire harness / under dash wire harness ecu axles motor mounts and shift linkage

 

thanks

 

what?

You dont need those harnesses. You will need the stock harness for your car. you will need aftermarket mounts and shift linkage. ecu. And someone to wire it up, like me.

 

+1........ hasport mounts is the way to go

 

I would also go with the hasport cable to hydro tranny conversion and run a hydro tranny.

 

Well if its a CRX SI, or Hf all you need is [Mounts,ecu,shift linkage] If its a vtec swap then thats all that needs to be wired...If you have a CRX Dx its a little more wiring but can be done ...Ohh and you will need to knock a dent in the frame rail next to were the alternator is located or it will rub...that should be it..

 

http://www.crxresource.org/modules.p...rticle&sid=134

http://rywire.com/store/faqdesk_info...877dd0772a4185

(this assuming youve already done mpfi or know how to)

/thread

 

So if mine is a dx what do I have to do differently about the wiring?

 

you have to swap mpfi, search google, there is a ton of write ups out there. just find the one that you think is the most accurate and in depth for you. dont start until you are sure you have read over everything twice so you dont mess something up and have to go back and fix it later.