You probably need a job!!

 

Ya i do need one of those LOL. Still waiting on word from Texas Instruments down in Dallas.

My current job is hijacking all of metalheads threads.

 

TI ehhh send me some of the quad processor pentak boards. And just a whole smattering of FPGA, EPROM, EEPROM, IC's you know just some spare parts and maybe a burner stand or two.

 

Didn't see ya...I was there from 10 - 1:30ish. Left for about an hour after some new girl on a Kat 600 ran into the side of a car in front of the BP. Figured I didn't need to hang out for the drama...

 

Yeah Alvin left shortly after 10, Chino and Oni and I rolled out shortly thereafter

 

Was it the girl on the skyish blue katana?

 

Looks good!

 

thanks.

too bad it's still not done

had some issues with sprocket clearance on the front, looks like i may end up running a jackshaft like i did on the old one. i'd rather not, but at least then i know it'll stay in one piece, and not leave me stranded on the side of the road.

other than the jackshaft, all i really have to do it make a brake line (running a hard line to the rear, no front brake) and the shift linkage, and she'll be good to go.

 

DO IT!DO IT!

 

i gotta get the jackshaft sprockets yo. were you able to get ahold of that place in chesapeake? i would have called, but if you have an account with them, it'd be easier for you to do it. and besides, i couldn't remember the name of the place, lol.