Ok i just installed my turbo timer in acordance with these instructions:
http://www.turbod16.com/viewtopic.php?f=22&t=23294

Now the problem is i can't remotely lock my car while its running off of the timer.

Any help would be apriciated.

 

Unhook all that and get rid of those t-taps cause they tend to cut the wires.
1. Pull the bottom dash off
2. There is a group of wires comeing from the ign. switch.
3. Take a meter or testlight whatever u have and probe the wires
4. White wire 12v and it will read 12v with the car on or off
5. Black/yellow ign. and it will only read 12v when u turn it to the on position
6. Yellow is the ACC. it will only read when on the on position.
Every wire u need is comeing form the ing.key if u have a problem hit me up im in Norfolk too.

 

Yeah i saw that i could wire it up that way on another site but my sodering iron shit on me.

 

U don't even have to solder just poke a hole in the wire then feed the other wire through like a needle and thread.

 

Ahhhhh, gotchya.

 

check out any install page