DSM garage sale
Thread Starter
Registered member
Joined: Sep 2006
Posts: 1,293
Likes: 0
From: Chesapeake
DSM garage sale
Like it states, I have way to much stuff in my garage from my 91 gsx. I'm fully negotiable on most stuff. So here goooooes:
6 bolt crank, needs turned $40
6 bolt rods/pistons (pistons are useless but they stay on) good for 2g piston setup SOLD
A/C compressor with bracket $30
1991 awd turbo m/t ecu (non-eprom) w/ new caps SOLD
stock cast turbo manifold $30
stock O2 housing $15
blue jdm valve-cover (looks good but could use a sand and finish, if your picky) $30
stock A/C fan $10
stock cam gears $10
NEW:
complete awd 4 bolt rear-end out of 94 tsi $300obo
2g 450cc blacktop injectors SOLD
Pinktop evo8 560cc injectors, low miles SOLD
Evo8 stock fuel rail $20
Brand new set of ARP rod bolts for 1st gen, SOLD
Brand new set of ACL Race series rod bearings, in unopened box SOLD
Brand new set of ACL standard series main bearings, in unopened box SOLD
I will add anything else when I get a chance to look through it.
Pictures available upon request.
6 bolt crank, needs turned $40
6 bolt rods/pistons (pistons are useless but they stay on) good for 2g piston setup SOLD
A/C compressor with bracket $30
1991 awd turbo m/t ecu (non-eprom) w/ new caps SOLD
stock cast turbo manifold $30
stock O2 housing $15
blue jdm valve-cover (looks good but could use a sand and finish, if your picky) $30
stock A/C fan $10
stock cam gears $10
NEW:
complete awd 4 bolt rear-end out of 94 tsi $300obo
2g 450cc blacktop injectors SOLD
Pinktop evo8 560cc injectors, low miles SOLD
Evo8 stock fuel rail $20
Brand new set of ARP rod bolts for 1st gen, SOLD
Brand new set of ACL Race series rod bearings, in unopened box SOLD
Brand new set of ACL standard series main bearings, in unopened box SOLD
I will add anything else when I get a chance to look through it.
Pictures available upon request.
Last edited by namehtcire; May 20, 2008 at 07:52 PM.
Thread Starter
Registered member
Joined: Sep 2006
Posts: 1,293
Likes: 0
From: Chesapeake
Re: DSM garage sale
Block hasnt been bored, but it might need to be. The wall in cylinder 1 is a little scratched, a hone may do it though, I'm not sure. The crank deffinately needs turned and it's just a stock crank pulled right out of the car and put up for sale.