Eagle Talon TSI 6bolt 2.3 liter
Thread Starter
pull you later
Joined: Aug 2004
Posts: 283
Likes: 0
From: HPT
Eagle Talon TSI 6bolt 2.3 liter
For Sale: 2.3 Eagle Talon TSI
Reason for sale is because I have a new addition to the family on the way.
Asking: $6,000 OBO I am very lieniant (SP?). So don't be afraid to throw an offer. Please fellas no low balling. I have a baby coming and really have to get rid of this... Remember shoot me an offer.
Mods:
build has about 5K miles on the bottom end
top end about 500 miles
-2.3 liter bottom end (bored .020 over)
-Eagle Rods (H-beam)
-Wiseco Pistons
-brand new crank when motor was built and fully balanced
-balance shafts removed
-new water pump
-new OE oilpump
-Forced performance (FP) 3X stroker cams
-all supertech valvetrain (dual valve spring with ti-retainers)
-HKS kevlar timing belt
-all new OE timing components
-Bullseye 60-1 P-trim Turbo
-750cc injectors
-walbro 255 fuel pump
-all S.S. Lines from the tank to the rail
-Aeromotive FPR
-FP Race exhaust Manifold with jet coating
-Full turbo back 3" Apexi N-1 exhaust
-turbosmart boost controller
-SBR Race IC kit w/ 2.5 piping
-Greddy type S BOV
-AEM EMS ( 3.5 bar map sensor, AIC sensor, EGT sensor, and all data cables are supplied)
-AEM gauge type UEGO wideband
-ACT2600 clutch
-fidanza 9lbs flywheel
-symbroski (SP?) shift kit (both inside and out of the car)
-FP Extended flywheel bolt kit
-Greddy turbo timer
-extra top line oil pump
If there is any other info needed, please email me at Expert612@yahoo.com this is the best method because i have my blackberry on me at all times. All tuning has been done by Dave Katz (if car is sold i will leave all available info to get in contact with him), a few people on here can vouche (SP?) For him. I'm will have picture ASAP. Also this car was intended for straight line use and never got around to doing suspension or any exterior fixings. Also It has never seen the dyno so I can give you ass dyno numbers. My tuner dave said it was around 500+ HP. Also the car spiked 30psi at one instance due to the need for an external gate. May part it out but would like to sell as a whole car... Thanks guys!
-Undrpressure23
Reason for sale is because I have a new addition to the family on the way.
Asking: $6,000 OBO I am very lieniant (SP?). So don't be afraid to throw an offer. Please fellas no low balling. I have a baby coming and really have to get rid of this... Remember shoot me an offer.
Mods:
build has about 5K miles on the bottom end
top end about 500 miles
-2.3 liter bottom end (bored .020 over)
-Eagle Rods (H-beam)
-Wiseco Pistons
-brand new crank when motor was built and fully balanced
-balance shafts removed
-new water pump
-new OE oilpump
-Forced performance (FP) 3X stroker cams
-all supertech valvetrain (dual valve spring with ti-retainers)
-HKS kevlar timing belt
-all new OE timing components
-Bullseye 60-1 P-trim Turbo
-750cc injectors
-walbro 255 fuel pump
-all S.S. Lines from the tank to the rail
-Aeromotive FPR
-FP Race exhaust Manifold with jet coating
-Full turbo back 3" Apexi N-1 exhaust
-turbosmart boost controller
-SBR Race IC kit w/ 2.5 piping
-Greddy type S BOV
-AEM EMS ( 3.5 bar map sensor, AIC sensor, EGT sensor, and all data cables are supplied)
-AEM gauge type UEGO wideband
-ACT2600 clutch
-fidanza 9lbs flywheel
-symbroski (SP?) shift kit (both inside and out of the car)
-FP Extended flywheel bolt kit
-Greddy turbo timer
-extra top line oil pump
If there is any other info needed, please email me at Expert612@yahoo.com this is the best method because i have my blackberry on me at all times. All tuning has been done by Dave Katz (if car is sold i will leave all available info to get in contact with him), a few people on here can vouche (SP?) For him. I'm will have picture ASAP. Also this car was intended for straight line use and never got around to doing suspension or any exterior fixings. Also It has never seen the dyno so I can give you ass dyno numbers. My tuner dave said it was around 500+ HP. Also the car spiked 30psi at one instance due to the need for an external gate. May part it out but would like to sell as a whole car... Thanks guys!
-Undrpressure23
Last edited by undrpressure23; Jun 14, 2008 at 03:21 PM.
Thread Starter
pull you later
Joined: Aug 2004
Posts: 283
Likes: 0
From: HPT
Thread
Thread Starter
Forum
Replies
Last Post