I need to see if anyone around here converts non vtec ecu's to vtec. I have a p06. Pm me if you can and how much. Thanks

 

You can get the parts from Xenocron.com, and anyone who can solder can install the parts for you.

 

I didn't use any parts when I converted them in the past, all you have to do is move a jumper or 2 its been a while since I did it but Ill try to look up the website I used.

 

You're confused. You're talking about converting an automatic tranny ECU to a manual tranny ECU. P06s are the same ECU as a P28, but they don't physically have the VTEC parts on the circuit board. Add the parts, and you have a P28. Don't add the parts, and you don't have VTEC. It's very simple. You can't add VTEC by moving jumpers around because you don't have any solenoid drivers..

 

Ooops your absolutely right I was thinking auto to manual conversion for some reason. I'm a bit tired lol.

 

what is the code inside the ecu it should be either 11f0 or 1728 and its printed inside the ecu on the curcuit board right on the top -center of the board and i charge $75.00
with a tune of your choice.