i should have read the first post a little harder lol

 

its all good, so i need to replace it? what about the iac valve? replace that too? and where the hell is the intake air temperature.

 

i just replaced my iac valve, and reset my ecu and stuff. its only throwing a iac valve still..... it might not be wired up right, but will that make my car run like shit and not idle and stuff? cuz sometimes when i start it up i hold the throttle to the floor and it just sputters and shuts off, or it sputters and then eventually it will rev up. let me know what you think.

 

Kinda sounds like you got the tps wired switched around with something else.

 

i dont know, i need some wiring diagrams or something..... all the wiring was done before i got the car, and it ran fine with the other motor in it.

 

Alright. I've seen this once or twice and have done it myself once. The wire that is on your IAC motor, put that on the TPS Sensor and then put the wire you currently have on the tps sensor on the IAC motor. See if it makes any difference and then let us know.

 

aight well i just went out there, didnt change anything, now its throwing the iac valve and a fuel injector system code, that just popped up!!!!

 

Try the thing i told you real quick ...it wont take but like 30 seconds

 

aight.......

 

Oh and then reset the ecu