DOHC ZC Head bolt torque specs....
#1
JDM IS THE NEW RICER
Thread Starter
Join Date: Sep 2007
Location: se7en cities
Posts: 1,524
Likes: 0
Received 0 Likes
on
0 Posts
![zc_god has disabled reputation](images/reputation/reputation_off.gif)
![Default](images/icons/icon1.gif)
like it says does anyone know the torque specs for the head bolts on a dohc zc engine... would be appreciated thanx
also does anyone know where i can get the head gasket and head bolts/studs? been lookin and found nothin.. and ive heard bad things about cometics for this engine...
also does anyone know where i can get the head gasket and head bolts/studs? been lookin and found nothin.. and ive heard bad things about cometics for this engine...
Last edited by zc_god; 04-17-2008 at 06:33 PM.
#3
Is Left Hand Shiftin
Join Date: Nov 2004
Location: NOVA
Posts: 772
Likes: 0
Received 0 Likes
on
0 Posts
![LD-rhdEG6 will become famous soon enough](images/reputation/reputation_pos.gif)
![LD-rhdEG6 will become famous soon enough](images/reputation/reputation_pos.gif)
![Default](images/icons/icon1.gif)
![](http://img.photobucket.com/albums/v681/turbod1point8/dohczc.gif)
5. Torque cylinder head attaching bolts in two steps; first to 22 ft. lbs., then to 61 ft. lbs. in sequence
6. Install timing belt with cylinder No. 1 at TDC of compression stroke and timing marks aligned
7. Torque intake manifold nuts to specifications using a crossing pattern in two or three steps.
Thread
Thread Starter
Forum
Replies
Last Post