97 GSR won't start after new clutch
#1
fuck this shit
Thread Starter
Join Date: Jul 2008
Location: VA Beach
Posts: 1,840
Likes: 0
Received 0 Likes
on
0 Posts
97 GSR won't start after new clutch
I tested everything. I am replacing starter now... It blew smoke when i tried starting it up first time. any suggestions?
Here's a list of what's new:
NGK Iridium spark plugs
NGK Wires
Replacement cap
Replacement rotor
Competition stage 2 clutch
stock, resurfaced flywheel
yes, i aligned everything right
yes the starter wires were all connected when said incident occured
and the grounds to thermostat
and grounds to starter.
Please help ASAP
Thanks
Here's a list of what's new:
NGK Iridium spark plugs
NGK Wires
Replacement cap
Replacement rotor
Competition stage 2 clutch
stock, resurfaced flywheel
yes, i aligned everything right
yes the starter wires were all connected when said incident occured
and the grounds to thermostat
and grounds to starter.
Please help ASAP
Thanks
#3
Re: 97 GSR won't start after new clutch
what do you mean by it wont start does it try to crank or not now did you see how much volts your putting out to the starter, see how many ohms your puting out the wire from the batt to starter, are you getting fuel to the injectors , are you getting spark to the plugs
i dont know how you replaced the clutch and what you did or didnt disconnect i would look and see if you have any plugs not hooked up first
hope this helps
i dont know how you replaced the clutch and what you did or didnt disconnect i would look and see if you have any plugs not hooked up first
hope this helps
#4
fuck this shit
Thread Starter
Join Date: Jul 2008
Location: VA Beach
Posts: 1,840
Likes: 0
Received 0 Likes
on
0 Posts
Re: 97 GSR won't start after new clutch
yes. i am getting all those things
charge from batt to starter
spark
just replaced fuel filter too.
idk wtf is going on with this stupid thing
charge from batt to starter
spark
just replaced fuel filter too.
idk wtf is going on with this stupid thing
#5
Re: 97 GSR won't start after new clutch
well if you cant get it running in a couple of days let me know and ill come take a look and see what your talking about
btw i bought that power lock mod from you
btw i bought that power lock mod from you
#6
fuck this shit
Thread Starter
Join Date: Jul 2008
Location: VA Beach
Posts: 1,840
Likes: 0
Received 0 Likes
on
0 Posts
Re: 97 GSR won't start after new clutch
put the clutch disk on alignment tool, put the small ring bearing on tool, jam in tranny, and bolt pressure plate housing
later i re-checked everything....
small ring bearing had busted. turned out i was right... it goes in this order, starting from block
Block --> ring bearing --> flywheel --> clutch disk --> pressure plate housing --> throw out bearing --> tranny
i believe that is correct, right?
#7
Slammedxpert
Join Date: Oct 2007
Location: Virginia Beach
Posts: 6,825
Likes: 0
Received 0 Likes
on
0 Posts
Re: 97 GSR won't start after new clutch
Damn, you threw a bunch of un-necessary parts at it.
Lol.
What is this "ring bearing" your talking about?
The one that goes in the flywheel....pilot bearing.....?
Lol.
What is this "ring bearing" your talking about?
The one that goes in the flywheel....pilot bearing.....?
Thread
Thread Starter
Forum
Replies
Last Post