1984 datsun s12 200sx drift build
fuck yea,
i might raise the front
when i drift in the rear i use high profile/any profile i get a hold on (tires)... probally going to make the rear higher
but if u think of it in a sense, the rear is a tad softer, which means under load and strees the rear should be pushed down lower as i transfer
i might raise the front
when i drift in the rear i use high profile/any profile i get a hold on (tires)... probally going to make the rear higher
but if u think of it in a sense, the rear is a tad softer, which means under load and strees the rear should be pushed down lower as i transfer
dude, i will be at hyperfest. i promise if i get a media pass i will shoot alot of pictures of you. i will be also shaking your hand if i can find you. your a trooper.
some older guy had a mint s12 at my work yesterday
some older guy had a mint s12 at my work yesterday
so walk over to drift nirvana and check it out for a bit, u dont really need a media pass just ask for the guy in the jeep to drive u to the pavilion points on track
made it home from hyperfest 20 min ago, we camped there
the car was alright, felt good, just no power. i need more power.
my valve cover gasket leaked lots of oil on my manifold causing some smoke,and i busted a p steering line on the ground so it was difficult to turn, but other then that i got some decent runs
the car was alright, felt good, just no power. i need more power.
my valve cover gasket leaked lots of oil on my manifold causing some smoke,and i busted a p steering line on the ground so it was difficult to turn, but other then that i got some decent runs





