Wont Start
Thread Starter
The Dune Coon
Joined: Nov 2002
Posts: 246
Likes: 0
From: Right near da beach
Re: Wont Start
main relay is fine checked it tonight, wiring is correct i checked it like a million times, tps and map arent crossed. It ran like a week or 2 ago but it had some check engine lights. It was like a code 7 10 and 14 i think i cant quite remember(like tps, iac, sumthin else) and i got rid of em all and now she wont start and if she does she jus cuts off.
Bitches get Stitches
Joined: Mar 2003
Posts: 3,959
Likes: 0
From: Chesapeake
Re: Wont Start
Originally Posted by llatidamn
that happened to me when my map and tps wires were crossed. they have the same plugs and its easy to cross them up.
Banned
Joined: Aug 2004
Posts: 43
Likes: 0
From: Virginia Beach
Re: Wont Start
There is a plug on your wiring harness that should be on the left side of the engine bay up near the firewall, if your looking at the engine from the front of the car then it will be the right side. There should be a plug that doesnt go to anything, its for a computer hookup I believe, make sure there is a cap on it, if the cap isnt there then the injectors wont work. Sounds stupid but without the cap the wires to the injectors are "broken".
Last edited by RandomHero; Nov 23, 2004 at 07:37 AM.
Ghost
Joined: Jul 2003
Posts: 8,841
Likes: 0
From: St Petersburg, FL
Re: Wont Start
Bad TPS? You have the check engine for it, and the symptoms aound like TPS issue?
I would also make sure your cam timing is good. Same for the MR2 above...the cam timing will slip and not be obvious (it' smore likely to skip off the main crank than the cam pulley, so the two cams will match up).
Good luck.
I would also make sure your cam timing is good. Same for the MR2 above...the cam timing will slip and not be obvious (it' smore likely to skip off the main crank than the cam pulley, so the two cams will match up).
Good luck.
Thread
Thread Starter
Forum
Replies
Last Post