bottom line is that she can be push started and everything runs fine. ive removed the starter and checked that. Its Fine. Also checked for the clutch saftey switch. The rubber piece did fall off but it shouldnt matter in a LS Integra because for the car to start the switch needs to be out, Which it is 24/7 without the Rubber piece. Only thing i dont think i checked was actually ignition switch. which im not to sure how to check. But other then that does anyone else have any ideas?

alright so i went out there and put the volt meter on the battery. it read 12.49. i also put it on the starter without cranking it 12.49. and when trying to start.... 12.49. any ideas? im sick of push startin this thing!

 

Does the starter solenoid get power when you crank it? If so the rules out a lot of shit.

 

alright so i went out there and put the volt meter on the battery. it read 12.49. i also put it on the starter without cranking it 12.49. and when trying to start.... 12.49. any ideas? im sick of push startin this thing!

 

You sure? Try pressing it with your fingers and turn the key then.

When you press the clutch is the starter clicking?

 

starter does not click what so ever. the safety switch is on the front side of the clutch petal not the back so the switch slides out to let the car turn on. i changed the ignition as well. nothing.

 

alright figured it out! there are two switches for the clutch. one down low and one all the way up top! pushed it in and it worked fine! thanks for looking everyone. Please Close